1·The outer layer of the flat panel in this design is typically a high voltage bias electrode.
本设计中的平板外层是一个典型的高电压偏置电极。
2·Applying the opposite voltage bias to widen the tunneling gap and raise the electrical resistance would reopen the switch.
施加反向电压以增大穿隧间隙，提高电阻，可以重新将开关断开。
3·A complete solution was given in the receiving circuit design to solve the technical problems such as high-voltage bias circuit and the pre-amplifier design.
接收电路设计给出了完整的解决方案，解决了高压偏置电路、前置放大器的设计等技术难题。
4·The success rate of porous conductive membrane preparation on fused silica capillary was greatly improved by control of voltage bias and electroosmosis effect.
通过控制电压偏置方向，利用电渗流效应使毛细管多孔导电膜的刻蚀成功率得到显著提高。
5·When measuring the leakage current with this setup, the voltage bias is applied to all the diodes simultaneously through the normally closed contact of each relay.
当利用这一配置测量漏流时，通过每个继电器的常闭触点同时向所有的二极管施加偏压。
6·The input bias current flows at the instrument input due to internal instrument circuitry and the internal bias voltage.
仪器内部电路和内部的偏移电压会在仪器的输入端引起输入偏置电流。
7·For capacitive sensing, driving signal with DC bias voltage and ac voltage is usually necessary for the measurement of capacitance.
对电容式加速度计，为测量其电容的变化，通常需要带直流偏置的交流电压信号来驱动。
8·Different bias voltage for the input buffer transistor.
不同偏置电压的输入缓冲晶体管。
9·Although it is possible to close multiple paths, this is practical only in DC testing, for example, to apply continuous bias voltage to a number of DUTs.
尽管可能会闭合多条路径，但实际应用中，只有在DC测试中才会用到，例如对多个DUT施加连续的偏置电压。
10·After the connections are made, verify the system is working properly by turning the bias voltage on and taking a current measurement with no ion beam current.
完成电路连接之后，接通偏置电压，在没有离子束电流的情况下进行电流测量，以验证系统能够正常工作。